Mobile Crossing WayPoint Map Loader Especificaciones descargar pdf (Pagina 134)

125

1. Remove the battery. and use the stylus to turn off the power and then back on. (Hard

reset)

2. Depress the voice memo button on the side of the unit.

3. While holding the button down, reinsert the battery and back cover.

4. Continue to hold the button down and look at the screen side - The top banner should

show “E-boot” after a short period.

5. Let go of the Voice Memo button.

6. The screen will prompt for the CF card. Insert it now if not already done. Wait for the

upgrade to finish.

7. Repeat step 1.

8. Reinsert the battery and battery cover. After a few seconds the standard WayPoint

PDA start screen should appear.

9. Follow the on screen instructions to set up your WayPoint PDA.

After the firmware is installed you can reload backups or software as needed

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 143 144

Sin comentarios

Mobile Crossing WayPoint Map Loader Especificaciones Pagina 134